UMI 3048 Bolt-in Coilover Brackets and Control Arm Relocation 1978-1988 G-body
$289.99
In stock
SKU
UPI3048
- This bolt-in rear coilover bracket kit is a coilover mounting solution for your factory axle 1978-1988 GM G-Bodies
- This race-proven lower bracket bolts in using the standard trailing arm mounting hole as well as an additional reinforcement hole normally used by the standard rear shock
- This bracket features a multi-position design to allow further fine tuning of ride height and shock location (±¾”)
- In addition to shock location adjustability, the UMI 3048 features three positions of trailing arm location adjustment to fine tune instant center
- This adjustment is popular on lowered cars, for drag racing traction, or whenever a geometry change is desired
- The kit also features upper reinforcement tabs to distribute the load from the T-bar as well as complete upper and lower hardware
- There is no cutting required and your car can be returned to stock at any time
- 100% designed, manufactured and raced out of Philipsburg, Pennsylvania USA and always US materials
- Installation & Fitment Note: Coilover brackets are designed to fit factory rear end housings ONLY and may not fit aftermarket rear ends
- UMI recommends installing this bracket kit, setting the ride height as desired, then purchasing the correct length shocks
- Rear shocks may not clear all exhaust tail pipes
- Key Features: ½” x 1-¼” mount fits most standard racing shocks
- Upper T-bar reinforcement tab and hardware included
- 100% Bolt in design features control arm relocation as well as shock height adjustability
- Brackets manufactured entirely from 3/16” Made In USA mild steel
- Laser cut for consistency and a precise fit
- Powder coated black for a long lasting finish
Write Your Own Review