Davies Craig 8660 Ford Coyote V8 Hose Adapter Kit for Electric Water Pumps

Davies Craig 8660 Block Adapter and Hose Kit: for adapting the Davies Craig remote electric water pumps to Ford Coyote V8 engines.  *** Please ask if you are unsure of your application ***

• The Davies, Craig EWP Coyote Header Adapter Kit has been designed for use with Davies Craig Electric Water Pumps (EWP) and Davies, Craig Thermatic Fans to replace your belt-driven mechanical fan and pump. This enables you to replace your existing belt-driven, mechanical water pump on Ford Coyote V8 engines.
• IMPORTANT Note: This header adapter plate is designed to fit in place of the original belt driven Mechanical Water Pump.  Upon removing the Mechanical Water Pump, you will need to ensure that you have the correct sized belt for reconfiguration.  Some belt / accessory drive fabrication will be necessary.
• Designed to be used with 8030, 8050 and 8070 electric water pump kits, may also work with 8025, 8040 and 8060 kits that do not include the pump controller.
• IMPORTANT: This kit only includes items listed below, electric water pump sold separately.  Removing mechanical water pump will also remove mechanical fan, electric fans sold separately.

Kit Contents:

• Ford coyote adapter plate qty 1
• 38mm straight adapter alloy qty 1
• 38mm (1½”) 90° rubber hose qty 1
• adapter o-ring qty 1
• o-ring small qty 1
• heater return alloy adapter 38mm qty 2
• in-line adapter nylon qty 1
• m5 bolts qty 6
• heater hose 19mm (44cm) qty 1
• adapter - 3mm rubber sleeve qty 2
• hose clamps - heater hose (small) qty 4
• hose clamps - large qty 4
• Installation instructions