Davies Craig 0445 Digital Radiator Fan Controller with 1/4" NPT Sensor

• Sensor 1: Temperature Probe (Air or Coolant  Fitment) 

• It senses air temperature as it passes through the radiator with the sensor placed in the radiator fin section or the sensor can also be placed directly into the coolant system in combination with a Temperature Sensor Adaptor Kit (Part 0409) which is available from our store. 
• Sensor 2: ¼ NPT Thermal Sensor Kit (Coolant Fitment Only) 
• The Thermal Sensor can be placed into the thermostat housing, engine block, or directly into the radiator. If you would like to install this sensor in the top radiator hose, It can also be used with Temperature Sensor Adaptor Kit (Part 0409) which is available from our store.
• The switch can run 1 or 2 fans and be used for 12 or 24 volt applications. It has an adjustable temperature range of 40ºC to 110ºC (104ºF to 230ºF) which can show Centigrade or Fahrenheit.
• Fan #1 will start once the temperature reaches the set temperature.
• Fan #2 (if applicable) will start operation 10 seconds after fan #1 starts. 
• The fan/s will operate until the temperature falls by 5°C below the set temperature.
• Sensor Wire length: 142cm in total (Wire from switch 112cm plus sensor connector 30cm)

Technical Specifications:

• Max voltage: 15V
• Max current: 50A
• Relay setup: Dual relay
• Speed: Single speed - 10 second delay to start up the second fan
• Applications: works with single and dual fan applications
• Temperature Display: LED digital temp display – actual temperature + set temperature
• Temperature Display: Centigrade+ Fahrenheit Temperature settings: 104 to 230º F (40 to 110º C)
• Temperature setting: Push Button
• Circuit type: Pre-programmed micro controller
• Output wires: Batt + Batt - IGN, AC Clutch, Fan #1, Fan #2 Thermistor Probe
• Dimensions: 3.75" x  2.6" x 2.2" (95 x 65 x 56 mm)
• 2 year warranty from Davies Craig

Kit Contents: Digital Fan Controller, Temperature Probe Sensor, ¼ NPT Thermal Sensor, Temperature Probe Mounting Kit, scotch lock (wire tap), yellow butt connector, ring terminal, and self tapping screws (2).