UMI 3049 1978-1988 GM G-Body Rear Coilover Bracket Kit, Bolt-In, Brackets Only
$339.99
Out of stock
SKU
UPI3049
UMI 3049 1978-1988 GM G-Body Rear Coilover Bracket Kit, Bolt-In, Brackets Only
- Designed for factory rear end housings only, see fitment note below
- Application:
- 1978 - 1988 Chevrolet Monte Carlo, Malibu, El Camino
- 1978 - 1988 Buick Regal, Grand National
- 1978 - 1988 Pontiac Grand Prix, LeMans
- 1978 - 1988 Oldsmobile Cutlass
- UMI’s bolt-in rear coilover bracket kit is a complete mounting solution for your factory axle 1978-1988 GM G-Body
- Brackets and hardware only, as pictured
- This race-proven lower bracket bolts in using the standard trailing arm mounting hole as well as an additional reinforcement hole normally used by the standard rear shock
- This bracket features a multi-position design to allow further fine tuning of ride height and shock location (±¾”)
- The kit also features upper reinforcement tabs to distribute the load from the T-bar as well as complete upper and lower hardware
- There is no cutting required and your car can be returned to stock at any time
- 100% designed, manufactured and raced out of Philipsburg, PA USA and always US materials
- Installation & Fitment Note: Coilover brackets are designed to fit factory rear end housings ONLY and may not fit aftermarket rear ends
- UMI recommends installing the 3049 bracket kit, setting the ride height as desired, then purchasing the correct length shocks
- Rear shocks may not clear all exhaust tail pipes
- Key Features: ½” x 1-¼” mount fits most standard racing shocks
- Upper T-bar reinforcement tab and hardware included
- Bolt in design features shock height adjustability
- Brackets manufactured entirely from 3/16”
- Made In USA mild steel
- Laser cut for consistency and a precise fit
- Powder coated black for a long lasting finish
Write Your Own Review